Measure each layer's near and far side from the line

At each height, the far side of the shape sets how wide the solid is and the near side sets its hole A shape that never reaches the line leaves a hole all the way through

Far side, near side

Each grid square is one unit. The line runs up the shape's right side.

Spin a shape turns a flat shape once round a dashed line, and you pick the solid it sweeps out. Every point keeps its distance from the line, so a point 2 units away traces a circle 4 units across.

More

Read the shape in layers from the bottom. In each layer, measure its far side from the line: twice that is how wide the solid is there. Then measure its near side. If it touches the line, the layer is solid; if a gap is left, the gap becomes a hole twice as wide.

Put the layers together and compare them with each option: the width, the height and the hole. The other solids come from the same shape spun round other lines, so a solid can be right in one way and wrong in another.

1Take the shape layer by layer.

2The far side sets the width: twice its distance.

3A near side that misses the line makes a hole.

Lesson help

Measure each layer from the line: the far side sets the width, and a near side that misses the line makes a hole.

About this lesson

Try the method in a practice when you are ready.

Report

Far side, near side

Spin a shape turns a flat shape once round a dashed line, and you pick the solid it sweeps out. Every point keeps its distance from the line, so a point 2 units away traces a circle 4 units across.

Read the shape in layers from the bottom. In each layer, measure its far side from the line: twice that is how wide the solid is there. Then measure its near side. If it touches the line, the layer is solid; if a gap is left, the gap becomes a hole twice as wide.

Put the layers together and compare them with each option: the width, the height and the hole. The other solids come from the same shape spun round other lines, so a solid can be right in one way and wrong in another.

1Take the shape layer by layer.

2The far side sets the width: twice its distance.

3A near side that misses the line makes a hole.

Each grid square is one unit. The line runs up the shape's right side.

Solid below, hollow above

The bottom layer runs from the line to 2 units away: it touches the line, so it is a solid disc 4 units across and 1 unit high.

The two layers above run from 1 to 2 units away. Their far side is still 2 units out, so the solid stays 4 units across, but their near side misses the line by 1 unit: a hole 2 units across, open at the top.

So the solid is a cylinder 4 across and 3 high, hollow at the top. That is the answer among the four.

The solid cut in half along the line: the step shape on both sides.

A shape away from the line

Measure the near side and the far side of each layer from the line, then choose.

Solid A
Solid B
Two of the four solids, drawn on one scale.

Try it

Which solid does the shape sweep out as it spins once round the dashed line?

  1. Solid A
  2. Solid B
Show the answer

Solid B

Right. Every layer starts 1 unit from the line, so a hole 2 across runs through, and the far side, 2 to 3 units out, makes the solid 4 units across at the bottom and 6 at the top.

Enable JavaScript to answer interactively and save your place.

Practice Spin a shape

Sign in free

Practice without limits and keep your progress.